NIC works!

Core Tip:
card failures not only affect the station itself, but also often affects the normal operation of the entire network, network administrators must draw attention. In Ethernet, the network card for connection and control of media access media access, Ethernet uses Carrier Sense Multiple Access / Collision Detection (CSMA / CD) is
; card failures not only affect the station itself,网络里的暧昧，我们玩不起!, but also often affects the normal operation of the entire network, network administrators must draw attention. In Ethernet, the network card for connection and control of media access media access, Ethernet uses Carrier Sense Multiple Access / Collision Detection (CSMA / CD) is to be achieved in the card.

same time, the NIC is also responsible for the formation of the upper layer protocol data unit protocol (PDU) composed of Ethernet data frames sent to the network, and is responsible for receiving and processing network, the Ethernet frames coming.

one card works

send data on the media card if the first listener carrier (the carrier by the voltage directive), if any, is that other sites are sending information to detect listen to media. Once the communication medium in a certain period of time (called the frame gap IFG = 9.6 microseconds) is quiet,Definitely worth the fine collection of Mito [17P], that is not occupied by other sites, then send the data to begin the frame, while continuing to listen for communication media, to detect the conflict. During the transmission of data.

If a conflict is detected, immediately stop the meeting to send to the media to send a wait a random time (CSMA / CD algorithm to determine wait time is the binary exponential backoff algorithm). Waiting for a random time, then a new transmission. If,prada handbags, after re-transmission times (greater than 16) are still in conflict to give up the transmission.

received, the card view for each frame transmission medium, if its length is less than 64 bytes, is considered to be fragments of the conflict. If the received frame is not a conflict of debris and the destination address is local address, then check the integrity of the frame, if the frame length is greater than 1518 bytes (known as jumbo frames, may be caused by the wrong LAN driver or due to interference) or failed CRC check, the distortion that occurred in the frame. By checking the frame is considered to be effective, it receives to carry out a card will be processed locally. Basic knowledge of computer

Second,chanel flap bag, the factors that influence the work of

NIC card can work depends on the card and its connection settings and LAN switching equipment produced by the interference of the working environment. Such as signal interference, ground interference,paul smith handbags, power supply interference, radiated interference can have a significant impact on the performance of the card, some interference may also be a direct result of card damage. Computer

PC unit causes power failure on the card is not working properly sometimes. Power failure may have fled to the discharge card jamming signal output port, before entering the network will take up a lot of network bandwidth, undermining the normal data packets of other stations to form a frame check a large number of FCS error packets, cause a lot of weight made frames and invalid frames, each workstation with its proportion of the increase of the actual flow, seriously interfere with the operation of the whole network system.

ground disturbances often affect the card work,alexa mulberry, bad grounding,7步还原魔方6个面！！？, static electricity due to the release of nowhere to continue to accumulate in the chassis,chanel bags, so that the card ground (the top iron through the network card is connected directly with the chassis) voltage normal, resulting in network card is not working properly, even when such a serious breakdown of control chip on the NIC card causing damage.

is very vulnerable to interference, and sometimes the network card and graphics card will be inserted too close to interfere. Interference is not serious, the card can barely work when the user data traffic is not often feel, but a large amount of data during the communication, under Windows98 will appear in the

NIC settings will also directly affect the speed of the workstation. PC card work for full-duplex and half duplex, when the servers, switches, workstations, working conditions do not match, such as servers,mulberry bags, workstations, network card is set to full duplex state, switches, hubs, and so work in half-duplex state, will have a large impact frame and frame number of FCS error checking, access speed will become very slow, from the server, copy a 20MB file may also need 5 to 10 minutes.

this mistake is often due to the negligence of the network maintenance personnel, most of the time they use the default settings, but does not verify the actual state. This article comes from:
【Comments】 【Tell friends】 【Print】 【Favorites】 【Close Window】 Previous: basic knowledge about firewalls
Next: TCP protocol encapsulation User Reviews articles form the latest list of articles TCP protocol works package format card! * Basic knowledge about firewall 32-bit and 64-bit operating system, the difference between the five most commonly used computer expert combination of key telephone system and the Service Desk of the computer beginners how to delete computer knowledge on a regular basis. Pwl file has How to help computer security defragging Foxmail write HTML e-mail message with the mode of self-Products