Preparing a Guitar for Painting : Musical Instruments

Preparing a Guitar for Painting When considering painting an electric guitar preparation is vital to achieving a great quality finish. Painting the guitar is only 1 small part of the method and the general rule is to ready your surface as well as you possibly can before applying any layers of paint. Depending on the porousness of the timber your guitar is constructed of you may or may not be required to utilize a timber grain filler up front. Timber grain fillers permit you to fill the pores of the timber which then allow a much more even surface for finishing. Loose grained timbers such as Mahogany <a href="http://www.guccibags-discount.com/coach-c-63.html"><strong>classic coach bags</strong></a> or Ash will most likely need grain filling whereas tightly grained timbers such as Alder or Maple usually don’t require grain filler. You need to truly work the grain filler into the timber first working with the grain and then against it till you are pleased with the application. Once applied let it set and then scrape back till the surface is relatively smooth. When sanding the guitar surface you should be attempting to achieve a flat finish, not always a shiny smooth finish as the primer will still result in a bristling effect on the timber but you should be looking to form a level surface free of any clear marks. Any raises or bumps in the timber have to be sanded out at this initial stage otherwise the layers of primer or paint will just exaggerate the blemish with each coat, removing these down the track can become a big issue and cost you a large amount of time. You should usually use a sanding block on the flatter surfaces and when sanding down a raised area in the timber employ a non flexible sanding block so that the contour of the sanding block won't form round the bump while you sand leaving the raised <a href="http://www.guccibags-discount.com/lv-epi-leather-pontnuef-gm-black-p-6635.html"><strong>louis vuitton outlet store</strong></a> area in place. When you are ecstatic that the surface is freed from any major scratches or raised areas you can move onto priming the timber ready for painting. Just remember the primer will highlight any deep scratches or raised areas so be assured you have prepped the surface as well as practical before moving onto this step. Preparing is best done using at least two coats and some sanding work in between. Apply the primer first round the edges of the guitar and then work your way toward the middle. Apply lightly <a href="http://www.cheapbeatsbydre-sales.com/kobe-bryant-limited-edition-monster-beats-by-drdre-studio-p-295.html"><strong>dreÂ*dreÂ*headphones</strong></a> and avoid any runs that will need to be fixed up after drying. The primer is applied for the sole point of permitting the paint to paste more effectively so make sure you guitar is covered and no bare areas are left. A rough surface will cause you to have to apply too many applications of paint and this is not ideal as you are attempting to cover the guitar and achieve a tough protective finish without completely drowning the natural tone of the timber. For more info and guides on guitar kits be certain to drop by eguitarkits.com the best resource for electric guitar kits online.